Accusys ACS-75170 User's Guide download pdf (Page 17)

English - 17

3. Turn on the computer system.

4. When the system prompts you to enter the BIOS setup

program shortly after power-on, follow the instructions

and enter the BIOS setup program. Set the hard disk drive

mode to “Auto”.

5. Save your changes to the BIOS setup program and reboot

the system.

6. After the boot process is complete, lock the new drive.

This identifies the new drive as the backup drive.

7. The system will immediately begin mirroring the data

from the first drive to the backup drive. Any old data on

the backup drive will be lost, and is overwritten with the

mirror image of the first drive.

Note: You need to repeat this procedure twice in order to

install a working Controller Box with a new pair of

larger drives without losing any data. The first step is

to mirror the data from the small hard drive, as source,

to a new larger hard drive, as target. The second step

is to mirror data from this new large hard drive, as

source, to a second large hard drive, as target. In this

case, you can omit steps 3, 4 and 5. However, under

DOS and Windows 3.1/95/98, you might not be able to

access the extra space if the existing data is stored in

an extended DOS partition. Under Windows NT, you

can use the Disk Administrator to create new

partitions in the extra space of larger drives.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

No comments

Accusys ACS-75170 User's Guide Page 17